Populating the PCBs

Finally install the voltage doubler links (Link1 and Link2).

IMPORTANT! If you have a transformer with dedicated 48V winding, you should NOT install these links. In this case the section marked "VOLTAGE MULTIPLIER" should be left unpopulated.

Use any of the CHASSIS pads to connect PSU ground to chassis star ground point.

There are three options for mounting the power transformer:

• Using threaded stud through the center of the transformer.
• Using cable ties.
• Off board near the IEC connector using mounting technique of your choice.

You can see the output polarity on the picture. V1 output is always referenced to ground/chassis and thus is always positive. V2 output is floating and can be made either positive or negative.

In order to get dual rail +/- output connect pins 1 and 2 ("GND" and "POS") of GND SEL header. In order to get two positive rails connect pins 2 and 3 ("GND" and NEG") of GND SEL header.

Testing procedure:

• Make sure you don't have any exposed wiring that can accidently short to ground or mains.
• Apply power to the transformer and measure output voltages at V1_DC, V2_DC and 48V_DC. Check that voltages are as expected.
• Adjust phantom power voltage with RVp1 until it reaches +48V at the 48V_DC pads. You may need to readjust this voltage after you finish the module assembly.